Installation precautions for Mercedes Benz G air suspension
The official website of AIRBFT air suspension introduces to you:Installation precautions for Mercedes Benz G air suspension,In order to better use the air suspension kit, please install it in the following way. Thank you for your understanding.
The Mercedes Benz G air suspension has lowered its height.
This is the height of the Mercedes Benz G air suspension after lifting, with a 4×4 feel.
Firstly, cut the rubber buffer block inside the front suspension spring onto the bracket. Please refer to the tape measure data in the picture for the specific cutting length.
After cutting, the measuring tape measures a depth of only 25mm on the inside.
This photo is what it looks like after cutting.
Then, it is necessary to drill a 12mm hole in the center of the spring base using an M12 drill bit to fix the airbag base here; Note that drilling is required at the bottom of both the front and rear four springs.
The above photo shows the drilled hole.
The above is a photo of the front air suspension airbag installed.
The lifting effect of the front air spring airbag of Mercedes Benz G air suspension.
At this time, the air spring airbag is lowered.
Let’s take a look at the rear suspension air spring airbag.
The rear air suspension airbag is very bulky.
This is the installation position of the front suspension height sensor.
This is also the installation position of the front suspension height sensor.
Let’s take a look at the installation position of the rear suspension height sensor for the Mercedes Benz G air suspension.
This is also the installation location of the rear air suspension height sensor.
Attention: The cylinder pressure sensor is installed on the left side of the solenoid valve, please refer to the picture.
The control system is installed in the trim panel on the left side of the trunk, which can provide a waterproof effect.
The air compressor and gas cylinder are installed at the bottom of the chassis, which saves space and is also very beautiful. There is a dedicated fixing bracket to fix them.
Explanation: This kit uses the original car shock absorber.
Note: When installing the front air spring airbag, it is necessary to cut off the rubber buffer block bracket inside the original vehicle spring; In addition, a 12mm hole shall be drilled in the center of the front and rear spring bases for fixing the air spring airbag base screws.
Reminder: If you do not like these changes, please do not purchase. Thank you.
The Mercedes Benz G air suspension kit not only allows the chassis to rise and fall, but also improves comfort. Moreover, when towing a RV or yacht, the rear suspension will not be lowered.
AirBFT Airride Product Operating Manual(V4-PH3)2022
